Remove CA Remove Inspections Remove Permits Remove Regulation
article thumbnail

Properties of Sand | Physical Properties of Sand | Chemical Properties of Sand

CivilJungle

The angularity of sand is measured by visual inspection using a low-power microscope. The porosity of the mould regulates its permeability, i.e. the capacity of the mould to allow the gasses produced during the spilling to pass through all the mould. The grains of sand range from well rounded, subrounded, angular and also very angular.

article thumbnail

Facilities Maintenance Checklist and Procedures

Job Order Contracting

Inspect electrical power panel. Inspect control panel for loose connections. Inspect Bollard/Barricade coatings, decals and paint. Visually inspect for corrosion. Inspect general arrangement of door and mechanism, mountings, standards, wind locks, anchor bolts, counterbalances, weather stripping, door sweeps etc.

professionals

Sign Up for our Newsletter

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

article thumbnail

Job Order Contracting – Audit Results

Building Information Management

JOC permits the issuance of job orders without competition because the tasks ordered were competed as part of the original award. SFPUC also inappropriately approved 5 task orders for federally funded projects, which occurred because federal regulations contradict the expectations of the SFPUC’s commission for JOCs. OBSERVATIONS.

article thumbnail

Job Order Contracting – Audit Results

Building Information Management

JOC permits the issuance of job orders without competition because the tasks ordered were competed as part of the original award. SFPUC also inappropriately approved 5 task orders for federally funded projects, which occurred because federal regulations contradict the expectations of the SFPUC’s commission for JOCs. OBSERVATIONS.

article thumbnail

STATE INCENTIVES GUIDE

Buisness Facilities Contributed Content

The capital credit is used only after all other deductions, losses or credits permitted under Titles 40 and 41 of the Code of Alabama 1975. The business must obtain a direct-pay sales and use tax permit from the State of Arkansas. This credit cannot be carried forward or back, and cannot be used to generate a refund to the taxpayer.

Income 75