The Constructor

MARCH 21, 2012

The size of movement depends upon the change in temperature and the coefficient of thermal expansion o f concrete. The coefficient of thermal expansion of concrete is influenced largely by the coefficient of thermal expansion of the aggregates since the aggregate occupies 70-80% of the volume of the concrete.

Concrete 194

Concrete Foundation Contract Materials 194

The Constructor

JANUARY 1, 2012

The benefits of using steel fibres in concrete are as follows: 1. Steel Fibres are generally distributed throughout a given cross section whereas reinforcing bars or wires are placed only where required 2.

Concrete 244

Concrete Foundation Materials Design 244

The Constructor

NOVEMBER 8, 2011

Cracks in reinforced concrete columns due to Steel Corrosion (cracks parallel to steel bars) 2. Cracks in reinforced concrete columns due to shrinkage of concrete 3. Cracks in reinforced concrete columns due to increased load on the slab 4. Cracks in reinforced concrete columns due to sulphate attack 5.

Concrete 223

Concrete Foundation Materials Contract 223

CivilJungle

APRIL 26, 2020

What Is Concrete? Concrete is the final product resulting from mixing cement , aggregates (including sand), water, and mixtures. The first use of concrete was by the Roman Empire. The Pantheon is the largest unreinforced concrete dome in the world, built-in 120 A.D. Different Types of Concrete. Dry lean Concrete.

Concrete 64

Concrete Roads Materials Foundation 64

The Constructor

NOVEMBER 8, 2011

This type of shrinkage is caused by the loss of moisture from the cement paste constituent, which can shrink by as much as 1% per unit length. Unfortunately, aggregate provides internal restraint that reduces the magnitude of this volume change to about 0.05%.

Concrete 229

Concrete Foundation Contract Materials 229

The Constructor

AUGUST 7, 2012

They may be load bearing, or they may be just decorative to act as a façade. The techniques that are used in the manufacture of panels permit a variety of finishes that imitate virtually any type of architecture at a fraction of the cost.

Concrete 190

Concrete Construction Foundation Materials 190

The Constructor

NOVEMBER 20, 2011

The concrete shall be deemed to comply with the strength requirements if: a) every sample has a test strength not less than the characteristic value;or b) The strength of one or more samples though less than the characteristic value, is in each case not less than the greater of : 1) The characteristic strength minus 1.35

Concrete 229

Concrete Design Foundation Materials 229

The Constructor

NOVEMBER 15, 2011

Nominal Mixes In the past the specifications for concrete prescribed the proportions of cement, fine and coarse aggregates. These mixes of fixed cement-aggregate ratio which ensures adequate strength are termed nominal mixes. These offer simplicity and under normal circumstances, have a margin of strength above that specified.

Concrete 240

Concrete Design Foundation Materials 240

The Constructor

AUGUST 10, 2012

These are the environments to which the concrete will be exposed during its working life. These are: Mild exposure Moderate exposure Severe exposure Very severe exposure, and Extreme exposure.

Concrete 181

Concrete Foundation Environment Materials 181

The Constructor

MARCH 21, 2012

in dry conditions), it should be suitable for use in concrete. Quality of Raw Materials: Cement: Provided the cement conforms with the appropriate standard and it has been stored correctly (i.e.

Concrete 230

Concrete Materials Foundation Design 230

The Constructor

MARCH 20, 2012

From the diagram above, we can see how the process unfolds. When the binding has set, the steel bars are placed into position.

Concrete 250

Concrete Foundation Materials Design 250

The Constructor

NOVEMBER 25, 2011

WHY WE TEST CONCRETE SRTRENGTH AFTER 28 DAYS? Tweet Why do we test concrete compressive strength after 28 days? The table below shows the compressive strength gained by concrete after 1, 3, 7, 14 and 28 days with respect to the grade of concrete we use.

Concrete 250

Concrete Foundation Materials Design 250

Civil Lead

APRIL 2, 2020

What is Prestressed Concrete? Concrete can withstand a great amount of compressive stress but it has a very low tensile strength. Because of low tensile strength, concrete gets cracks when subjected to maximum load. Why prestressed concrete is used? When water comes in contact with these cracks the steel gets corroded.

Concrete 81

Concrete Foundation Design Comparison 81

The Constructor

MARCH 22, 2012

Water within the hardened cement paste is forced to more as a result of the applied load. This movement of moisture is the primary cause of creep deformation. Some movement also occurs due to the propagation of microcracks. The movement due to creep can be greater than the elastic strain on loading.

Concrete 141

Concrete Foundation Materials Contract 141

The Constructor

MARCH 23, 2012

There are two ways of overcoming this problem: Embed another material in the concrete which is strong in tension – reinforced concrete Remove the tension altogether – by arching or prestressing.

Concrete 133

Concrete Foundation Materials Comparison 133

The Constructor

MARCH 25, 2012

The following figures illustrate the precast concrete process: 1. The individual components are prefabricated off site then taken to site where they are erected.

Concrete 143

Concrete Foundation Materials Transportation 143

The Constructor

NOVEMBER 22, 2011

It has many advantages when compared to the normal conventional concrete. Fly ash is considered as one of the waste industrial product that cannot be easily disposed. It solves the problem of disposal of flyash and at the same time it reduces the cost of the construction.

Concrete 224

Concrete Foundation Materials Design 224

The Constructor

MARCH 25, 2012

WHAT IS PRECAST CONCRETE? WHAT IS PRECAST CONCRETE? Tweet Precast concrete is cast under factory controlled conditions and not erected on site until it is fully hardened. Just like in-situ concrete, precast concrete can be plain, reinforced or prestressed concrete.

Concrete 130

Concrete Foundation Materials Contract 130

The Constructor

NOVEMBER 21, 2011

Both the rate and degree of hydration, and the resulting strength of the final concrete, depend on the curing process that follows placing and consolidating the plastic concrete. This reaction, called hydration, produces a stone-like substance—the hardened cement paste.

Concrete 189

Concrete Foundation Materials Design 189

CivilJungle

OCTOBER 29, 2020

Roller Compacted Concrete. Roller Compacted Concrete also know as RCC. Roller Compacted Concrete takes its name from the construction method used to build it. Roller-compacted concrete has the same basic ingredient as conventional concrete: cement , water, and aggregates , such as gravel or crushed stone.

Concrete 40

Concrete Roads Transportation Foundation 40

The Constructor

MARCH 25, 2012

There is no grout loss, such as that from badly fitting formwork, which results in poor quality concrete like shown below.

Concrete 171

Concrete Foundation Materials Design 171

The Constructor

MARCH 20, 2012

Cleanliness: when repairing concrete, care must be taken to remove any dirt or dust that will prevent the repair concrete bonding with the parent concrete. Expediency: The longer the repair is left, the more work has to be done, and the less likely that the repair will blend in.

Concrete 247

Concrete Portland Foundation Materials 247

The Constructor

AUGUST 24, 2012

Cladding panels behave like wall panels and are therefore subjected to the same forces, i.e. axial compression, horizontal flexure due to wind, and in-plane and out-of-plane shear.

Concrete 127

Concrete Foundation Materials Contract 127

The Constructor

MARCH 19, 2012

Depending on how big or complicated the pour is, the inspection may just take few minutes or it could take hours.

Concrete 235

Concrete Inspections Foundation Materials 235

The Constructor

AUGUST 7, 2012

This allows a greater performance from the cladding panel than simple building enclosure.

Concrete 223

Concrete Foundation Maine Materials 223

The Constructor

JANUARY 22, 2012

The stress strain curve of concrete lies between those of the aggregate and the cement paste. The aggregate is more rigid than the cement paste and will therefore deform less (i.e. have a lower strain) under the same applied stress.

Concrete 137

Concrete Foundation Materials Contract 137

The Constructor

DECEMBER 17, 2011

It is new technique involved in the civil engineering.Reactive powder concrete in made by replacing the conventional sand and aggregate by grounded quartz less than300 micron size, silica fume, synthesized precipitated silica ,steel fibers about 1 cm in length and 180 micron in diameter.

Concrete 161

Concrete Portland Foundation Materials 161

The Constructor

NOVEMBER 17, 2011

The shells are most commonly flat plates and domes , but may also take the form of ellipsoids or cylindrical sections, or some combination thereof.

Concrete 212

Concrete Foundation Materials Design 212

CivilJungle

DECEMBER 25, 2021

Asphalt is utilized for constructing and maintaining roads, parking areas, road tracks, anchorages, field runways, bike lanes, sidewalks and play and sports areas. What Is Asphalt Road? Asphalt road shells have numerous benefits similar to cost-effectiveness, noise pollution, and comfort reduction. Quiet Pavement.

Roads 98

Roads Concrete Transportation Materials 98

The Constructor

AUGUST 18, 2012

The initial setting time should not be less than 1 hour and to be within 25% of the result with distilled water.

Concrete 139

Concrete Foundation Materials Contract 139

The Constructor

NOVEMBER 28, 2011

Procedure for measuring bulk density of concrete is as per IS 1199 – methods of sampling and analysis of concrete.

Concrete 133

Concrete Foundation Materials Design 133

The Constructor

NOVEMBER 21, 2011

The concrete can be specified in two ways : a) by proportioning of the constituents /ingredients (nominal mix) b) by required strength (Design mix) Concrete is mixed by any two methods, based on requirement as per quality and quantity of concrete required.

Concrete 122

Concrete Foundation Materials Design 122

Construction Marketing

NOVEMBER 9, 2020

They’re used in the construction of roads, bridges, dams, power plants, quarries, airports, farms, buildings, and residential areas, such as homes. However, in recent years, this construction equipment has been used for mining, grading, earthmoving, excavating, dredging, as well as grading the soil for a new road or highway.

Equipment 156

Equipment Roads Materials Transportation 156

The Constructor

NOVEMBER 11, 2011

Home News Videos Tips Building Building Bye Laws Building Materials Aggregates Cement Wood Building Tips Buildings Green Buildings Flooring Formwork/Shuttering Paints & Decoratives Skyscrappers Smart Materials Concrete Concrete Admixtures Concrete Cracks Crack Repair Concrete Durability Concrete Properties Concrete Types Fibre reinforced Fire Proof (..)

America 203

America Concrete Foundation Airports 203

The Constructor

NOVEMBER 16, 2011

There should be good transport facilities such as railway, bus service, for going to office, college, market, etc. The site should be in fully developed area or in the area which has potential of development. The site should command a good view of landscape such a hill, river, lake, etc.

Residential 240

Residential Site Plans Concrete 240

The Constructor

JANUARY 14, 2012

Home News Videos Tips Building Building Bye Laws Building Materials Aggregates Cement Wood Building Tips Buildings Green Buildings Flooring Formwork/Shuttering Paints & Decoratives Skyscrappers Smart Materials Concrete Concrete Admixtures Concrete Cracks Crack Repair Concrete Durability Concrete Properties Concrete Types Fibre reinforced Fire Proof (..)

Concrete 203

Concrete Foundation Materials Contract 203

The Constructor

DECEMBER 14, 2011

The term is also used variously to describe the beam of the system, or the vehicles traveling on such a beam or track. The term originates from the contraction of the words mono (single) and rail, from as early as 1897, as early systems used metal rails.

Concrete 113

Concrete Transportation Foundation Contract 113