Architecture Design Documentation Inspections 
The Constructor
MAY 29, 2012
Hence, the bridge must be regularly inspected and maintained for the benefit of its users. There are three levels of inspection: 1. General inspection: Usual inspection of representative parts of a structure. General inspection: Usual inspection of representative parts of a structure.
Construction Specifier
JANUARY 12, 2021
This standard specification establishes criteria for concrete construction that can be incorporated by reference into contract documents. When an architect or engineer (A/E) cites ACI 301, the document is intended to be adopted in its entirety into the contract documents. Section 14—Precast Architectural Concrete.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Building Information Management
NOVEMBER 18, 2015
This policy applies only to a facility that is a building, the design and construction of which is governed by accepted building codes, or a structure or land, whether improved or unimproved, that is associated with a building. Providing for INSPECTION, VERIFICATION, AND TESTING necessary for acceptance of the facility by the District.
BD+C
AUGUST 28, 2023
Navigating challenges in construction administration 0 qpurcell Mon, 08/28/2023 - 14:25 Building Team Vessel Architecture's Rebekah Schranck, AIA, shares how the demanding task of construction administration can be challenging, but crucial. This enables them to identify potential modifications prior to the finalization of documents.
The Constructor
NOVEMBER 15, 2011
IS 456-2000 has designated the concrete mixes into a number of grades as M10, M15, M20, M25, M30, M35 and M40. In this designation the letter M refers to the mix and the number to the specified 28 day cube strength of mix in N/mm2. These mixes of fixed cement-aggregate ratio which ensures adequate strength are termed nominal mixes.
The Constructor
NOVEMBER 20, 2011
III Concrete which does not meet the strength requirements as specified in I, but has a strength greater than that required by II may, at the discretion of the designer, be accepted as being structurally adequate without further testing. times the standard deviation; and 2) 0.80 times the standard deviation; and 2) 0.80
Lets Build
APRIL 15, 2020
The business models, though, are of two forms — it’s either design, bid, build where the project owner chooses a contractor after the design phase or design-build where both design and construction phases are done by one contractor. Are all contract documents signed? The process. master plan, education brief)?
Expert insights. Personalized for you.
147 
Let's personalize your content